Attention:

The configuration examples listed here are to be understood as configuration suggestions. Depending on the system, further adjustments may be required.

If the configuration examples contain an individual code (please also refer to Mail Processing Ruleset generator Custom commands), it is to be checked in any case whether

•the respective example fully matches the requirement.
 

•any further individual adaptations are required.
 

•the corresponding code causes the desired behaviour without side effects.

If combinations of these code examples are required,

•the correct sequence when placing them in the ruleset
 

•possible interactions with already existing codes

are to be observed.

Information relating to third-party providers does not claim to be up-to-date.
If articles relating to third-party systems are out of date, we will be pleased to receive your comments under our support address support@seppmail.ch.

In any case, the configuration must be tested before a system goes live.